Snapper 75438 manual #6-3318TWIN BAG GRASS CATCHER KIT for

#6-3318 TWIN BAG GRASS CATCHER KIT for

SNAPPER 28" & 33" REAR ENGINE RIDERS & 33” LAWN TRACTORS

This grass catcher kit fits Lawn Tractors with 33” Decks and Rear Engine Riders with 28” & 33” Decks. On Series “A” & Later Lawn Tractors, Adapter Kit #6-1334 must be installed before this grass catcher can be installed. On Series “0-2” Lawn Tractors, Adapter Kit #6-1068 must be installed before this grass catcher can be installed. Install adapter kit as described by instructions provided with kit.

WARNING

DO NOT attempt any maintenance, adjustments, service, or repairs with engine running. STOP engine. STOP blade. Set park brake. Remove key. Remove spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid burns, allow sufficient time to cool.

STEP 1: Bumper Support Bracket & Muffler Guard Installation (Riders Only)

Remove the muffler mounting screw and the two screws from the R.H. side of the standup bumper. Install the bumper support bracket and muffler guard against the standup bumper. Align the holes and reinstall screws; tighten securely. See Figure 1.

FIGURE 1

STEP 2: Removal Of Deflector

Remove wing nut, flat washer and bolt from deck (save for use in step 4). (Riders) Flip up deflector, do not remove. (Tractors) Remove the hinge nut, spring and hinge pin from deflector. Remove deflector. Save for future use when not bagging grass. See Figure 2.

STEP 3: Air Lift Installation

An optional Air Lift Kit 6-1777 has been included with this grass catcher and may be installed to enhance bagging performance in certain conditions. The air lifts can be installed by reaching through the discharge opening or by removing the blade. Attach one air lift to each end of the blade using the hardware and instructions provided in the kit. Be certain to install lifts on both ends of blade. Torque nuts and bolts on air

lifts to 20 to 30 ft. lbs. Torque blade retaining hardware to 45 to 55 ft. lbs. See Figure 3.

NOTE: Not all original equipment or accessory blades will accept the Air Lift Kit. Contact an authorized dealer if you have questions.

FIGURE 2

FIGURE 3

WARNING

The cutting blades and the edges of the cutting deck are extremely sharp and can cause severe injury. Always wear heavy leather gloves when working around cutting blades and the cutting deck.

INSTRUCTION No. 7-5438 (I.R. 1/31/03)

1