Snapper 7600004 manual Unit assembly

3

unitassembly

REMOVE BOLTS,

THEN REMOVE

COVER

CHECK TO SEE

THAT BELT IS

ON PULLEYS

DRILL

HOLES &

INSTALL

BOLTS

INSERT

PIN

ALIGN

BRACKET

WITH REAR

OF DECK

INSTALL

BOLTS

STEP 6a: Remove bolts securing impeller pulley cover to blower, and remove cover.

STEP 6b: Check to see that blower belt is routed around impeller pulley and idler pulleys after belt is installed onto deck pulley. Replace cover, tighten- ing bolts securely. IMPORTANT: Never operate any mower without a pulley guard securely in place.

STEP 7: Slip tube of locking pin bracket into blow- er mount, and secure with T-handle pin, making sure pin goes through both upper and lower holes in blower mount. Then align base of pin bracket parallel with rear of deck, and, using bracket as a template, drill two 7/16” holes through deck. Insert two 3/8-16 x 1” hex bolts up through deck and bracket, securing with hex flange lock nuts. Tighten securely. IMPORTANT: Use gloves when working under deck. Sharp blades can cause injury.

STEP 8: Lay supplied pulley guard onto deck, aligning holes in guard with holes in deck. Install with bolts securing original guard, tightening securely.

NOTE: 48” deck shown; 52” and 61” deck guard configurations may differ.

6