unit
assembly
3
STEP 9: Install belt guard between pulley guard and belt guard support clip on front part of blower mount. Secure with two 5/16 nylon wing nuts. Tighten nuts securely.
WEIGHT KIT INSTALLATION
!!Warning: Weight kit must be installed prior to installing clamshell kit. Failure to do so may result in longitudal tipping of unit.
STEP 10: Lay weight mount channel, with installed weights, across front end of machine as shown. Secure to machine with two clamp plates, one under each caster arm, each held on with two 3/8- 16 x 4” hex bolts and lock nuts. See Inset. Tighten securely.
CLAMSHELL KIT INSTALLATION
STEP 11: Install bumper mount standoffs onto rear bumper of machine, utilizing existing hardware on machine. NOTE: Invert hardware when installing standoffs, installing bolts out through bumper with nuts facing out.
NOTE: When installing standoffs, be sure that the bumper mount plate mounting holes along the back bar of both standoffs are oriented towards the right side of the machine. Refer to the Parts List section of the manual.
STEP 12: Install bumper mount plate onto stand- offs with four
INSTALL BELT GUARD
AND SECURE WITH
WING NUTS
WEIGHT |
|
MOUNT | CLAMP |
CHANNEL | PLATE |
USE EXISTING
HARDWARE
7
