Installation Instructions
Install Bagger Mount
1)Remove three bolts – two on the rear of the tractor frame, and the top bolt on the right rear of the tractor frame. See Figure 1. The two rear bolts will be replaced with longer bolts supplied in the kit. Save the right bolt for re- installation.
Install Grass Bag Support
1)Align the lower
‘Hitch
Mount’ hole
Figure 2
Figure 1
2)Align the holes in the Bagger Mount Weldment (P/N 7400272A) with the holes in the tractor frame.
3)Install one bolt
4)Install two bolts
5)Tighten all hardware securely.
2)Secure the Grass Bag Support to the Bagger Mount with the Mounting Pin (M720527). Hold the pin with the leg up. Insert the Mounting pin fully into the Bagger Mount. Rotate the mounting pin so that the leg will be pointing down, locking the pin in place. See Figure 3.
Figure 3
3 | Instruction Manual No. 7102356 (Rev. C, 06/04/2008) |
| TP |