Operation
Operation (Continued)
Starting and Operation (Continued) | Stopping |
|
| |||
Propelling the Mower |
| 1. Stop forward motion of the mower by releasing the |
| |||
|
| wheel drive control. |
|
| ||
1. Start the engine. Refer to the Section entitled “Starting | 2. Stop the engine and blade by releasing the blade |
| ||||
control. |
|
| ||||
and Operation – Engine and Blade”. |
|
| ||||
|
|
|
| |||
2. Move the ground speed control (A, Figure 4) to the | Handle Height Adjustment |
| ||||
desired speed position. |
|
| ||||
|
|
|
|
| ||
3. Squeeze the wheel drive control (B) against the handle | The height of the mower handle can be adjusted as follows: | |||||
to engage the wheel drive and propel the mower | ||||||
1. Loosen the lower nuts (A, Figure 5) on each lower |
| |||||
forward. Forward speed can be adjusted while the |
| |||||
handle. |
|
| ||||
mower is moving by changing the position of the |
|
| ||||
|
|
|
| |||
ground speed control. |
|
|
|
|
| |
| A |
|
|
|
| |
B | Reproduction |
| B | |||
|
|
|
| |||
|
|
|
|
| ||
|
|
|
| A |
| |
Figure 4: Mower drive controls |
| Fig | re 5: Adjusting the handle height |
|
| |
|
|
|
|
| ||
|
| 2. Move the handle assembly (B) up or down until the |
| |||
|
|
| esired position is achieved. |
|
| |
|
| 3. Tighten the lower nuts each lower handle to maintain | ||||
|
| the desired position. |
|
| ||
|
| ! | WARNING |
| ! | |
|
| DO NOT attempt any maintenance, adjustments or service | ||||
|
| with engine and blade running. STOP engine and blade. | ||||
|
| Disconnect spark plug wire and secure away from spark | ||||
|
| plug. Engine and components are HOT. Avoid serious |
| |||
|
| burns, allow sufficient time for all components to cool. |
8 | www.snapper.com |