Snapper 7800600, 7800602 Installing the Discharge Deflector, Installing the Grass Bag Adapter

Operation

Operation (Continued)

!	WARNING			!	Installing the Grass Bag Adapter
					(Optional Accessory on Some Models)
DO NOT attempt any maintenance, adjustments or service
					1. Remove the recycling cover. Refer to the Section enti-
with engine and blade running. STOP engine and blade.
					tled “Recycling Operation”.
Disconnect spark plug wire and secure away from spark
					2. Install the adapter (A, Figure 10) to the deck in place of
plug. Engine and components are HOT. Avoid serious
					the recycling cover, making sure that:
burns, allow sufficient time for all components to cool.
					The front hole (B) on the outside front of the
					adapter fits over the stud where the front of the
Installing the Discharge Deflector					recycling cover was originally secured
					The slot (C) on top of the adapter slips under the
1. Remove the recycling cover. Refer to the Section enti-
					restraining nut on top of the deck (under the right
tled “Recycling Operation”.
					front corner of the engine)
2. Install the deflector (A, Figure 9) to the deck in place of
					The slot (D) on the rear of the adapter slips onto
the recycling cover, making sure that:
					the stud behind the rear of the discharge opening,
	The front hole (B) on the outside front of the
					where the rear of the recycling cover was
	deflector fits over the stud where the front of the
					originally secured.
	recycling cover was originally secured
					3. Install the internal/external tooth lock washers and knob
	The slot (C) on top of the deflector slips under the
					nuts onto the studs and tighten securely.
	restraining nut on top of the deck (under the right
					4. Route the recoil rope arou d the outside of the rope
	front corner of the engine)
					guide pulley (E).
	The slot (D) on the inside rear of the deflector slips
	onto the stud behind the rear of the discharge				N te: The reco l	pe may need to be slackened. Refer to the section
	opening, where the rear of the recycling cover was
					entitled “Star ng and Operation - Engine and Blade”.
	originally secured.
3. Install the internal/external tooth lock washers and knob
nuts onto the studs and tighten securely.						E
	C		B				C
									B
	D
						D
		A						A
		Reproduction
Figure 9: Installing the discharge deflector					Figure 10: Installing the grass bag adapter
					!	WARNING			!
					DO NOT operate without entire Grass Catcher or guard
					in place. Grass Catcher components are subject to
					deterioration during normal use. Inspect frequently and
					replace worn or damaged components immediately.

10 www.snapper.com