Snapper Clean Sweep Triple Catcher Initial Hitch & Tube Installation, Install Tubes & Deflector

Initial Hitch & Tube Installation

A

C

B

D

Figure 4. Install Back Plate (Flat Style Bumper shown)

A.	Back Plate and Support	C. Hitch Plate
B.	Hair Pin	D. Rod

A B

Figure 6. Upper Tube Length

A

C

B

Figure 7. Mount Deflector and Tube Pivot

A. Tube Pivot C. 5/16” Mounting Hardware B. Deflector

			G
		D
			C
					H
A			E
		B	L
F					I
		E
A. Deflector	F. Locknut, 5/16-18		K. Capscrew,	J	M
					N
B. Back Plate	G. Upper Tube		#10-32 x 1/2
C. Capscrew,	H. Middle Tube		L. Nut, #10-32		K
5/16-18 x 1	I.	Lower Tube	M. Clip
D. Socket	J. Washer, #10		N. Holes
E. Washer, 5/16

Figure 5. Assemble Tubes & Deflector

Install Tubes & Deflector

1.Some 50” models covered by this manual require upper tube (G, Figure 6) to be shortened. Shorten tube by cutting through along line “B” line. See Figure 5.

2.If not already done, insert the upper tube (G, Figure 5) into the socket (D). Insert the tube from the front. This will require some effort.

3.Mount the socket (D) and deflector (A) to the back plate (B) using the four 5/16-18 x 1 capscrews (C),

eight flat washers (E), and four nylock nuts (F) as shown in Figures 5 & 7.

4.Insert the lower tube (I, Figure 5) into the middle tube

(H). Secure the tubes as shown in Figure 5 using #10-32 x 1/2 capscrews (K), washer (J) and #10-32 nut. Insert middle tube (H) (Secure the elbow to the turbo using clip (M). Clip (M) may need to be relocat- ed to a different set of holes (N) to ensure secure fit.

Note: Use correct hole locations to maintain proper tube connections and prevent lower tube from disconnecting from the turbo.

12