Snapper Clean Sweep Twin Catcher Initial Hitch & Tube Installation, Assemble Tubes & Deflector

Initial Hitch & Tube Installation

A

A. Upper Tube	D
B. Middle Tube	E
C. Lower Tube
D. Nut, Nylock, 10-24 x 3/4	B
E. Washer
F. Screw, Truss Head, 10-24	D
G. Holes
H. Clip and Hardware	E
	F

C

G

F

H

Figure 4. Assemble Tubes & Deflector

Assemble Tubes & Deflector

1.Insert the lower tube (C, Figure 4) into middle tube

(B). Secure the tubes as shown in Figure 4 using #10-24 x 3/4 screws, washer (E) and #10-24 nuts

(D). Insert middle tube (B) into upper tube (A). Secure the tubes as shown in Figure 4 using #10-24 x 3/4 screws, washer (E) and #10-24 nuts (D).

2.Place upper tube into catcher opening. Secure the elbow to the turbo using clip (H).

Note: Relocation of clip and hardware (H) to holes (G) may be necessary to ensure proper fit. Use correct hole locations to maintain proper tube connections and pre- vent lower tube from disconnecting from the turbo.

A H G

F

E

B

	D
	C
Figure 6. Assemble Catcher Bags
A. Clip	E. Clamp
B. Cloth Bag	F. Nut
C. 5/16-18 x 3/4 Carriage Bolt	G. Lockwasher
D. Hanger Bracket	H. Wire Hoop

Assemble Catcher Bags

1.See Figure 6. Insert the wire hoop (H) through the cloth bag (B).

2.Install the clamp (E) and hanger bracket (D). Secure with two 5/16-18 x 3/4 carriage bolts (C), lockwashers

(G) and nuts (F).

12