Snapper Clean Sweep Twin Catcher manual Install Deflector, 50” Models, 44” Models

Initial Turbo Installation

Install Deflector

1.See Figure 6. Drill four 13/64” holes from the bottom of the deflector at the pre-molded drill points (A, bot- tom of deflector).

2.Attach the deflector to the support rod wire-form using four #10-14 x 3/4 truss head screws and nylock nuts.

B

A

C

Figure 6. Install Deflector

A. 13/64 Hole Locations C. Screws, #10-24 x 3/4 B. Nylock Nuts

Install Belt Guide

1.See Figure 7 & 8. Locate the taptite screw that will be replaced by capscrew (C). Remove and discard the taptite screw

2.Assemble the 5/16-18 x 1-1/2 capscrew (C), lock- washer (E), washers (B), belt stop (D) and spacer

(A).

3.Secure the belt stop assembly to the deck in the loca- tion shown.

Note The belt stop (D, Figures 7 & 8) is located and ori- ented differently in 44” and 50” applications. For all applications, when turbo is installed, belt stop (D) should be outside the belt 1/8” away from the backside of the belt.

50” Models E C

D

B

A

Figure 7. Install Belt Guide
A. Spacer		D. Belt Stop
B. 5/16 Washers		E. Lockwasher,
C. Capscrew, 5/16-18 x 1-1/2		5/16
44” Models	E	C

B D

A

Figure 8. Install Belt Guide
A. Spacer	D. Belt Stop
B. 5/16 Washers	E. Lockwasher,
C. Capscrew, 5/16-18 x 1-1/2	5/16

6