Snapper CP215517HV PRE-START Check List, Starting & Operation 2.2.1. Engine & Blade

Section 2 - OPERATING INSTRUCTIONS

2.1PRE-START CHECK LIST

Make the following checks and perform the service required before each start-up.

2.1.1.Check guards, deflectors, grass bag, adapter and covers to make sure all are in place and securely tightened.

2.1.2.Check blade control and wheel drive control to insure they work freely. See Figure 2.1.

WHEEL DRIVE

2.1.6.Clean exterior surfaces of cutting deck and engine of any accumulation of spilled fuel, dirt, grass, oil, etc. Keep engine air intake screen and cooling fins clear at all times.

2.2STARTING & OPERATION 2.2.1. ENGINE & BLADE

1. Turn fuel valve to on. See Figure 2.4. Move

engine speed control to the “choke” position. The

CONTROL

BLADE CONTROL

choke should not be required to restart a hot

engine. See Figure 2.3.

NOTE: Stop the engine (and blade) by releasing the blade control.

WHEEL DRIVE

CONTROL

BLADE

CONTROL

FIGURE 2.1

2.1.3.Check cutting height. Adjust to desired

height.

2.1.4.Check engine oil and add oil as needed to bring level up to the full mark. Refer to Engine Owner’s Manual for oil specifications. See Figure 2.2.

FULL MARK

(DO NOT OVER FILL)

ENGINE SPEED CONTROL (SHOWN IN CHOKE POSITION)

FIGURE 2.3

2.Pull blade control against handle.

3.Pull rope start handle to crank engine.

4.After engine starts, move engine speed control away from the choke position to the “Fast” (Rabbit) position. See Figure 2.3.

5.Allow a brief warm-up until engine runs smooth.

FIGURE 2.2

2.1.5.Add fuel to tank after pushing the mower outside where fumes can safely dissipate. Make sure cap is tightened after refueling. Refer to Engine Owners Manual for specifications.

6