Snapper ECLP21602KWV Recycling Operation, Installation of Grass Catcher

Section 2 - OPERATING INSTRUCTIONS

2.6 RECYCLING OPERATION

Converting this mower to the recycling operation requires no tools. First, STOP engine. Raise discharge door located at rear of machine. Remove grass catcher. Insert recycling plug fully into discharge opening. Allow discharge door to close. See Figure 2.8.

NOTE: For best recycling results, cut up to a maximum of 1/3 of grass blade length and recycle ONLY when grass is dry.

1.Set the cutting height at the highest cutting position.

2.Move engine speed control to “FAST” (Rabbit) position.

3.Move ground speed control to slowest speed setting.

4.Proceed mowing slowly. If grass is very dense, raise cutting height to improve recycling performance.

LIFT DISCHARGE

DOOR

INSERT

RECYCLING

PLUG

FIGURE 2.8

2.7INSTALLATION of GRASS CATCHER

1.Follow WARNING statement found on this page.

2.Lift discharge door located at the rear of machine. See Figure 2.9.

3.Install grass catcher onto the rear of machine. Position the rod ends of catcher frame over the tabs located at the rear of deck. Release discharge door, which is spring loaded, onto top of grass catcher.

LIFT DISCHARGE

DOOR

FIT ROD ENDS	TABS
OVER TABS

CATCHER

HANDLE

GRASS

CATCHER

FIGURE 2.9

WARNING

DO NOT operate mower without entire grass catcher, side chute or recycling plug in place. Grass Catcher components are subject to deterioration during normal use. Inspect frequently and replace worn or damaged components immediately.

WARNING

Grass Catcher bags used on SNAPPER products are made of woven fabric, and are subject to deterioration and wear during normal usage. Check condition of bag before each use. Immediately replace worn or damaged catcher bags with only bags recommended by SNAPPER. The grass catcher is optional equipment on some models.

9