Snapper EI55224, EI7244 Annually END of Each Season, Engine Spark Plug, Storage Procedure

Section 3 - MAINTENANCE

3.4 ANNUALLY (END OF EACH SEASON)

Perform all maintenance as described in the maintenance schedule.

3.4.1. Engine

Refer to engine owner’s manual for service instructions.

3.4.2. Spark Plug

Refer to engine owner’s manual for service instructions.

3.5 STORAGE PROCEDURE

Refer to the Engine Owner’s Manual for directions regarding engine storage preparations. Prepare the snow thrower for “end of season” storage as follows:

1.	Drain fuel from fuel tank and let engine run until
all fuel is out of the carburetor.
2.	Disconnect and remove the spark plug wire
away from spark plug before any other
preparations are made!
3.	Tape all openings closed to prevent spraying
water into exhaust or air intakes during washing.
4.	Tilt snow thrower up on its wheels and
thoroughly clean the underside of the auger.
5.	Lubricate all exposed metal with a light coating
of oil to prevent corrosion.
6.	Store the machine in a shed or other dry area,
protected from weather.
3.6 MAINTENANCE and SERVICE PARTS
		MAINTENANCE and SERVICE PARTS
		Auger Drive Belt (Tecumseh Engines)	1-5152
		Wheel Drive Belt (4 HP & 5 HP Engines)	1-5151
		Wheel Drive Belt (5.5 HP Engines)	4-5214
		Wheel Drive Belt (6 HP & 7 HP Engines)	2-3416
		Scraper Blade (22” Width Auger)	3-3298
		Scraper Blade (24” Width Auger)	3-6163
		Rubber Drive Tire	2-3364
		Shear Bolts - 1/4-20 x 1-1/2”	1-5257
		Hex Nuts - 1/4-20	7-6978
		Parts Manual for Intermediate Frame Snow Thrower - Series 4	#06068
		Domestic Models: I4223, I5223, I55223, I6223, I7243,
		European Models: EI5223, EI55223, EI55224, EI7243, EI7244

13