Snapper ELP21702BV Operating Instructions, 2.1PRE-STARTCHECK LIST, Figure

Section 2 - OPERATING INSTRUCTIONS

2.1PRE-START CHECK LIST

Make the following checks and perform the service required before each start-up.

2.1.1. Check guards, deflectors, grass bag, adapter and covers to make sure all are in place and securely tightened.

WARNING

DO NOT start or operate this machine without installing the recycling plug or the entire grass catcher.

2.1.2.Check blade control and wheel drive control to insure they work freely. See Figure 2.1.

BLADE

CONTROL

WHEEL

DRIVE

CONTROL

FIGURE 2.1

2.1.3.Check cutting height. Adjust to desired height.

2.1.4.Check engine oil and add oil as needed to bring level up to the full mark. Refer to Engine Owner’s Manual for oil specifications. See Figure 2.2.

OIL

FILL/CHECK

FUEL CAP

FIGURE 2.2

2.1.5.The battery should be removed from its carton and filled with electrolyte. Refer to Section “BATTERY SERVICE” for battery preparation.

2.1.6.Add fuel to tank after pushing the mower outside where fumes can safely dissipate. Make sure cap is tightened after refueling. Refer to Engine Owners Manual for specifications.

2.1.7.Clean exterior surfaces of cutting deck and engine of any accumulation of spilled fuel, dirt, grass, oil, etc. Keep engine air intake screen and cooling fins clear at all times.

2.2STARTING & OPERATION 2.2.1. ENGINE & BLADE

(Primer Models) (Recoil Start)

1.Move engine speed control to the “Fast” (Rabbit) position. See Figure 2.3.

IMPORTANT: Stop the engine (and blade) by releasing the blade control.

	BLADE
TO START	CONTROL
	TO STOP

SLOW

ENGINE

SPEED

CONTROL

FAST

CHOKE (KAWASAKI)

PRIMER

BUTTON

FIGURE 2.3

2.Push primer button three times to start a cold engine. NOTE: Do not use primer button to start warm engine.

3.Pull blade control against handle.

4.Pull rope start handle to crank engine.

5.After engine starts, allow a brief warm-up until engine runs smooth.

6