Section 3 – MAINTENANCE
3.1 | INTRODUCTION | 3.2.2. CHECK GREASE LEVEL IN TRANSMISSION |
| To retain the quality of the mower, use genuine | 1. Remove transmission fill plug. Roll machine |
| SNAPPER replacement parts only. Contact a local | forward or backward while looking down into plug |
| SNAPPER dealer for parts and service assistance. | hole. |
| For the correct part or information for a particular | 2. If liquid grease IS NOT visible on the input gear |
| mower, always mention model and serial number. | (the small gear below the plug hole), add an |
3.2 | SERVICE - AFTER FIRST 5 HOURS | amount, to cover gear, of Snapper “00” grease. See |
Figure 3.2. | ||
| 3.2.1. CHANGE ENGINE OIL |
|
WARNING
DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool.
1.Refer to Engine Manual for proper oil specifications and procedures.
2.For simplest/cleanest oil change, loosen lower handle wing nuts and stand mower up on lower handle as shown in Figure 3.1. Drain oil through dipstick tube into a container.
FIGURE 3.1
IMPORTANT: Drain fuel tank before tipping mower.
FILL PLUG
FIGURE 3.2
NOTE: Snapper “00” Grease (Part No.
(Continued on Next Page)
11
