Snapper FB13250BS, GM2515KAW, GM2513H manual Troubleshooting, Adjustment, & Service, Serial Number

Troubleshooting, Adjustment, & Service

TRAVEL CONTROL ADJUSTMENT

Serial Number 0-011903999

1.The Travel Control engagement bars (A, Figure 16a) should be an equal distance from the Upper Handle Bar. If they are not, adjust their position.

2.Loosen the wing nut locknut (D) and rotate control rod (C) until engagement bars are properly adjusted.

3.Tighten locknut to secure adjustment.

A
B
	A
C	D

Serial Number 012003001-Up

The Travel Control engagement bars (A, Figure 16b) can be adjusted to provide the optimum ratio of forward/reverse travel speed.

1.Remove the hair pin clip (B, Figure 16b).

2.Relocate the L-shaped end of the control rod (C) into one of the four speed adjustment holes in the engagement bar side plate.

The rearmost hole will provide the most forward speed and the least reverse speed, and vice-versa. Finer adjustment can be obtained by loosening the jam nut (D) and turning the rod in or out.

3.Secure the in the desired position by replacing the hair pin clip (B).

Figure 16a - Travel Controls Adjustment

A.Engagement Bars

B.Upper Handle

C.Control Rod

D.Wing Nut Locknut

A
D
C	B

Figure 16b - Travel Controls Adjustment

A.Engagement Bars

B.Hair Pin Clip

C.Control Rod

D.Jam Nut

16