Snapper WLT180H421BV2, WLT200H481BV2 important safety instructions D4SWIVELiiiiiill

Section 4 - ADJUSTMENT & REPAIR

_ILWARNING

DO NOT attempt any adjustments, maintenance or service with the engine or blades running. STOP blades. STOP engine. Set brake. Remove key. Remove spark plug wire from spark plug and secure wire away from spark plug. Engine and components can be extremely hot. Avoid burns by allowing engine and components sufficient time to cool.

4,4.7. TRACTION DRIVE BELT REPLACEMENT 48" Mower Deck Removal

RIGHT

SIDE

DECKHANGER _SHOW_

_ BRACKET

.':4.o;J . I _ _!_,_

o5'* f	"1=_	FRONT
• .I	: _

It is necessary to remove deck in order to replace belts.

Remove deck as follows:

1.Place tractor on a firm, level surface such as a driveway or garage floor and set the park brake.

2.	Turn engine "OFF". Remove key.	FRONT
3.	Lower the deck to lowest setting.	LIFT ARM	H _.IR PIN

4.Disconnect the front lift rod assembly from the

front hanger bracket. See Figure 4.25. FIGURE 4.26

8.Remove hair pins from the front deck hanger rod and slide out the rod from deck hanger bracket.

Front lift arms will be now be disconnected.	See	ELECTRIC
Figure 4.26.		CLUTCH

BELL CRANK

LEVER

ROD

• DECK

BELT

d4SWIVELiiiiiill

FRONT LIFT ROD

FIGURE 4.27

HA,RP,N--

(Continued On Next Page)

BRACKET

48" DECK SHOWN

FIGURE 4.25

6.Turn the front wheels to the left.

7, Hold front of deck "UP" and slide the front deck hanger rod to the right and out then lower the front of deck to the ground.

8.Remove deck drive belt from engine pulley bottom groove. See Figure 4.27.

26