Snapper NP2167519B Pre-Start Check List, Starting and Operation, Mower controls, A Operation

Operation

Pre-Start Check List Starting and Operation

Make the following checks and perform the service required before each start-up.

1.Check the guards, deflectors, grass bag, adapter, and covers to make sure all are in place and securely tightened.

2.Check the blade control (A, Figure 1), wheel drive control (B), and ground speed control (C) to insure they work freely.

A

C

B

Figure 1: Mower controls

3.Check the cutting height. Adjust to the desired height. Refer to the Section entitled ‘Cutting Height Adjustment’.

4.Check the engine oil (A, Figure 2) and add oil as needed to bring the level up to the full mark. Refer to the Engine Owner’s Manual for oil specifications.

B A

Figure 2: Oil and fuel fill

5.Add fuel to the tank after pushing the mower outside where fumes can safely dissipate. Fill the tank to 1-1/2 inches below the top of the filler neck (to allow for fuel expansion). Make sure the cap (B, Figure 2) is tightened after fueling. Refer to the Engine Owners Manual for fuel specifications.

6.Clean the exterior surfaces of the cutting deck and engine of any accumulation of spilled fuel, dirt, grass, oil, etc. Keep the engine air intake screen and cooling fins clear at all times.

Engine and Blade (Briggs Quantum and Intek Series Engines)

1.Move the engine speed control to the fast (‘Rabbit’) position.

2.Push the primer button (A, Figure 3) three times to start a cold engine.

NOTE: The primer should not be required to restart a warm engine.

NOTE: Briggs Quantum Series engines are equipped with a Ready StartTM feature, and thus do not feature a primer button.

A

Operation

Figure 3: Engine primer

3.Pull the blade control (A, Figure 4) against the handle.

4.Start the mower:

Manual Start Models: Pull the rope start handle (B) to crank the engine.

Electric Start Models: Insert the key (C) into the ignition switch. Turn the key to crank the engine.

5.After the engine starts, allow a brief warm-up until the engine runs smooth before beginning mower operation.

NOTE: To stop the engine (and blade), release the blade control.

A

C

B

Figure 4: Starting the mower

5