Snapper Out Front Z-rider Mower manual Service & Lubrication, Decals, Hours, Procedure, Comments

SERVICE & LUBRICATION

HOURS	PROCEDURE	COMMENTS
BREAK-IN	Check all Grease Points and add if necessary
........................................................	Check all Fasteners for proper tightness.
DAILY	Remove Debris from under Belt Cover	More often if needed.
........................................................	Sharpen Cutter Blades	Tighten to 60-75 Ft.-Lbs.
........................................................	Grease Cutter Spindle Bearings	Use Chevron SRI Grease or equal.
........................................................	Inspect Interlock Switches for Damage	Replace if Needed.
........................................................	Inspect Belts for Wear or Damage	Replace if Needed.
WEEKLY	Check Tire Pressure	Add or Adjust as required.
........................................................	Check Safety Interlock System	Inspect OPC Switch for proper Operation.
........................................................	Grease Caster Wheel Bearings	General Purpose Grease.
........................................................	Grease Caster Support Arms	General Purpose Grease.
........................................................	Grease Idler Arm Pivots on Cutter Deck	General Purpose Grease.
MONTHLY	Lube Controls and Linkages	Use Medium Duty Oil.
........................................................	Gear Box Lubrication	Use 80W90 Gear Oil
........................................................	.....................................................................................	(Total Capacity is 16 Ounces)

DECALS

DECAL P.N. 7-3647

DECAL P.N. 4-6371 DECAL P.N. 1-3010

8