IMPORTANT SAFETY INSTRUCTIONS

WARNING: This powerful machine is capable of amputating hands and feet and can throw objects that can cause injury and damage! Failure to comply with the following instructions may result in serious injury to the operator or other persons. The owner of the mower must understand these instructions and, furthermore, must allow only persons who understand these instructions to operate mower. Each person operating the mower must be of sound mind and body and must not be under the influence of any substance which might impair vision, dexterity, or judgment. If you have any questions pertaining to your mower which your dealer cannot answer to your satisfaction, call or write the Customer Service Department at SNAPPER, McDonough, Georgia, 30253. Phone: (770) 954-2500.

PROTECTION FOR CHILDREN

1.DO NOT allow children in area when mower is being operated.

2.DO NOT allow pre-teenage children to operate mower.

3.Allow only responsible teenagers or adults with mature judgment to operate mower and only under close supervision.

4.Keep the area clear of all persons, particularly small children, and pets.

PREPARATION

1.Never operate mower without proper guards, plates, safety switches, or other safety protective devices in place and properly connected. Inspect to determine that these safety devices are installed properly, are in good repair, and operate properly. If the condition or operation of these devices are questionable, they must be repaired or replaced before using the mower. Be thoroughly familiar with the controls and proper use of the equipment.

2.Thoroughly inspect the area where the mower is to be used and remove all stones, sticks, wire, bones and other foreign objects. Also note the location of holes, stumps, and other possible hazards.

3.DO NOT operate mower when barefoot or wearing open sandals. Always wear substantial footwear and long pants.

4.Fill fuel tank before starting engine. Use approved fuel container. DO NOT smoke near open fuel container. DO NOT fill fuel tank indoors or when engine is running. Allow engine to cool for at least ten minutes before refilling. Wipe off any spilled fuel before starting engine. DO NOT run engine indoors.

5.Make sure that the wheel drive clutch control is disengaged before starting engine.

6.Never attempt to make a cutting height adjustment while the engine is running.

7.When mowing over rough ground or in tall grass, mower must be set at highest cutting position.

8.Mow only in daylight or in good artificial light.

9.Never operate mower in wet grass. Always be sure of your footing; keep a firm hold on the handle and walk; never run!

10.DO NOT operate mower without the grass bag (and adapter), side chute, mulch cover or adapter plug in place.

OPERATION

1.DO NOT change engine governor settings or over speed engine.

2.DO NOT put hands or feet near or under rotating parts. Keep clear of discharge area while engine is running.

3.STOP engine when crossing gravel drives, walks, or roads, and under any conditions where thrown objects might be a hazard.

4.After striking a foreign object or if mower vibrates abnormally, STOP the engine, disconnect and secure spark plug wire. Inspect the mower for any damage and repair the damage.

5.STOP blade and engine whenever you leave the operating position behind the handle for any reason, including clearing grass, emptying grass bag and making any adjustments, repairs, or inspections.

6.Before cleaning, repairing or inspecting, make certain blade and all moving parts have STOPPED. Disconnect and secure spark plug wire away from plug to prevent accidental starting.

7.STOP engine and wait until the blade comes to complete STOP before removing grass bag and/or clearing grass.

8.Mow across slopes, never up-and-down. Exercise CAUTION when changing directions on slopes. DO NOT mow steep slopes or other areas where stability or traction is in doubt.

MAINTENANCE AND STORAGE

1.Keep all nuts, bolts, and screws tight to be sure mower is in safe operating condition.

2.Never store mower with fuel in tank inside of a building where fumes may reach an open flame or spark. Allow engine to cool before storing in any enclosure.

3.To reduce fire hazard, keep mower free of grass, leaves, spilled fuel or excessive grease.

4.Check grass bag assembly frequently for wear or deterioration. Replace with new bag if loose seams or tears are evident. Replace slider or bag adapter if broken or cracked.

5.Have your mower inspected and serviced each year by an authorized Snapper dealer. Determine if any additional devices are available which might upgrade the safety of your mower.

6.Factory specified Snapper replacement parts must be used to assure adequate protection against injury.

2

Page 2
Image 2
Snapper R205012, NR205012, NR205012, R204513E, R205012 important safety instructions Important Safety Instructions

NR205012, R204513E, R205012, R205012, NR205012 specifications

Snapper NR205012, R204513E, R205012, and NR205012 are essential models in the Snapper lineup, renowned for their performance, reliability, and advanced features tailored for gardening enthusiasts and landscaping professionals alike. These models boast powerful engines designed for efficiency and durability, ensuring that users can tackle various tasks with ease.

One of the main features of the Snapper NR205012 model is its robust 20-inch cutting deck, which offers exceptional maneuverability and precision in cutting. This feature enables users to navigate around tight corners and obstacles, making it ideal for residential yards and commercial landscaping projects. The R204513E, on the other hand, incorporates an advanced rear-wheel drive system that enhances traction and control on uneven terrains, allowing for a seamless mowing experience.

In terms of technology, the Snapper lineup is equipped with innovative engine designs that provide fuel efficiency without compromising power. The overhead valve (OHV) technology used in these models ensures cooler operation and reduced emissions, contributing to a lower environmental impact. Furthermore, the Self-Propelled Drive System featured in the R205012 allows for easy handling, even during longer mowing sessions, while significantly reducing user fatigue.

The NR205012 model is designed with user comfort in mind. It features an adjustable handle height, providing ergonomic support to accommodate different user preferences. This attention to comfort is coupled with easy-to-use controls that minimize complexity, making the mowing experience enjoyable for both seasoned landscapers and novice users.

Durability is another hallmark of the Snapper NR205012 series. Built with high-quality materials, these models are designed to withstand heavy use, ensuring they can operate in demanding conditions over time. The rust-resistant components and reliable construction ensure that users can enjoy a long-lasting product, reducing the need for frequent replacements or repairs.

In summary, Snapper NR205012, R204513E, R205012, and NR205012 embody a blend of power, technology, and user-friendly features, making them excellent choices for anyone looking to enhance their lawn care routine. With their efficient engines, innovative drive systems, and focus on durability, these models are positioned as leaders in the world of outdoor power equipment, delivering exceptional performance and ease of use across various applications. Whether for home gardens or professional landscaping, Snapper ensures that users can achieve immaculate results with every cut.