DEALER SET-UP INSTRUCTIONS & CHECKLIST For
SNAPPER REAR ENGINE RIDERS
Tools required for
A package of Battery Acid (Electrolyte), purchased separately, is required for electric start models.
SNAPPER Rear Engine Riding Mowers are shipped with steering components, seat & fuel tank detached. After uncrating, inspect the machine for damage, then proceed as follows to assemble and prepare the unit. Open parts box and hardware bag and identify components shown on pages 5, 6, & 7. NOTE that NOT ALL PARTS in each bag are used on any one rider.
A. STEERING COMPONENTS
1. Steering Shaft | |
(a) | Carefully stand Rider on rear bumper. |
(b) | Push steering shaft into place (See figure 2). |
(c) | Remove/discard vinyl cap from steering shaft |
end. | |
(d) | Tap upper bushing so that it contacts control |
panel. | |
(e) | Place thrust washer on top of bushing. |
(f) | Install 3/16” x |
into steering shaft above thrust washer. | |
(g) | Install bushing cover over |
2.Installing Tie Rods - Narrow Front Frame (28” & smaller deck)
(a)Install bushings onto tie rods.
(b)Install tie rods into steering shaft. Secure with 3/8” flat washers and 5/32” x 1”
STEERING
SHAFT
TIE
ROD
washer and bushing. |
(h) Slide foam steering shaft cover over steering |
5/32” X 1”
BUSHING
3/8” FLAT WASHER
shaft. See Figure 1. |
FOAM STEERING
SHAFT COVER
THRUST
WASHER
BUSHING COVER (CUP DOWN TO COVER COTTER
PIN)3/16” X
COTTER PIN
UPPER BUSHING
CONTROL
PANEL
FIGURE 1
COTTER PIN
FIGURE 2
3.Installing Tie Rods - Wide Front Frame (30” & larger deck)
(a)Install tie rods, 5/16” lock washers and 5/16”- 24 hex nuts. Tighten securely. See Figure 3.
STEERING
ARM
TIE ROD
5/16” SPLIT LOCKWASHER
5/16” HEX NUT
FIGURE 3
INSTRUCTION No.