Snapper Rear Engine Riders manual E.Operator’S Seat - Hinged Seat Models

Models: Rear Engine Riders

1 6
Download 6 pages 6.55 Kb
Page 3
Image 3
E.OPERATOR’S SEAT – HINGED SEAT MODELS

E.OPERATOR’S SEAT – HINGED SEAT MODELS

1. Fold the hinged seat plate forward and follow steps 4 through 8 in Section “OPERATOR’S SEAT, NON-HINGED MODELS” for 8 & 10HP models. See Figure 8.

5/16” PATCH LOCK SCREWS

ADJUSTING

KNOBS &

SPACERS

FRONT

OF SEAT

FIGURE 8

F.BATTERY

The batteries for the electric start models are shipped dry. It should be activated and charged according to the instructions below.

1.BATTERY REMOVAL

(a)Remove battery cover by pulling each side away from ratchet fasteners. See Figure 9.

2.BATTERY ACTIVATION

(a)Place battery in a well ventilated area on a level surface.

(b)Remove battery cell caps. Fill cells as required with electrolyte to between minimum and maximum fill line as viewed from outside battery case. Filling battery with electrolyte will bring the battery to 80% charged state.

WARNING

The electrolyte (acid) produces a highly explosive gas. Keep all sparks, flame and fire away from area when charging battery or when handling electrolyte or battery. Electrolyte (acid) is a highly corrosive liquid. Wear eye protection. Wash affected areas immediately after having eye or skin contact with electrolyte (acid). Battery acid is corrosive. Rinse empty acid containers with water and mutilate before discarding. If acid is spilled on battery, bench, or clothing, etc., Flush with clear water and neutralize with baking soda. DO NOT attempt to charge battery while installed on the RIDER. DO NOT use “BOOST” chargers on the battery. DO NOT OVER FILL!

NOTE: The recommended level of electrolyte is 3/16” above cell plates. DO NOT place anything in battery other than specified electrolyte.

3.

PULL COVER AWAY FROM

RATCHET FASTENERS ON

BOTH SIDES

BATTERY CHARGING

(a)With all cell caps removed, connect an automotive type battery charger to battery terminals; RED to positive (+) and BLACK to negative (-) terminal.

(b)Slow charge at 2 to 6 amps for 30 minutes.

(c)After charging, check level of electrolyte, add electrolyte if necessary, and tighten cell caps.

FIGURE 9

(b)Remove the hair pin and swivel from the deck support to allow clearance for battery removal.

(c)Remove battery from battery compartment.

3

Page 3
Image 3
Snapper Rear Engine Riders manual E.Operator’S Seat - Hinged Seat Models