Snapper TP 100-400 manual Discharge Tube Installation, Installed on turbo housing

Discharge Tube Installation

Landlord/1700 Series (Mfg. No. 1692095)

1.Install the spring clip (D, figure 18) with two 10-32 x i/2 truss head screws (E), four flat washers (F), and two locknuts (G).

2.Install l/4-20 x 5/8 carriage bolt (H) through hole in turbo housing. Secure with l/4-20 flange locknut (I).

3.Position the lower tube (C) onto turbo housing and hook inside spring clip onto flange locknut (I, installed in step 2). Mark hole location on opposite side of turbo housing for outer spring clip.

4.Remove lower tube and drill 9/32 hole in turbo hous- ing and install l/4-20 x 5/8 carriage bolt (H) through hole. Secure with l/4-20 flange locknut (1).

5.Assemble the upper tube (A) onto middle tube (B) as shown in figure 2 with two 1032 x l/2 truss head screws (E), four flat washers (F), and two locknuts 63.

6.Install two lo-32 x l/2 truss head screws (E), four flat washers (F), and two locknuts (G) to the top holes in the lower tube (C). Leave hardware loose.

7.Install upper tubes (A and B) to lower tube (C) and tighten hardware.

8.Install tube assembly into cart sleeve and onto turbo housing. Hook spring clips (D) onto flange locknuts

(I)installed on turbo housing.

“2.347

Figure 18
A. Upper Tube	F. Washer
B. Middle Tube	G. Locknut, 10-32
C. Lower Tube	H. Carriage Bolt, 1/4-20x 518
D. Spring Clip	I. flange Locknut, l/4-20
E . Truss Head Screw, lo-32	x l/2