Section 3 - MAINTENANCE
3.3SERVICE EVERY 25 OPERATING HOURS 3.3.1. ENGINE
5.Air Filter
c. Reinstall air cleaner cover. Insert tabs located on the engine cover into corresponding slots in air cleaner cover. IMPORTANT: The yellow tabs must be completely inserted into air cleaner cover or the compartment will not be completely sealed to prevent debris from entering into the carburetor.
a. 16 HP Engines: Change air filter. Pull up and rotate the air cleaner latch to remove cleaner cover. See Figure 3.4.
IMPORTANT: When cover is removed, you are viewing the carburetor side of the air filter, which will appear clean. Remove filter and
AIR CLEANER
LATCH
| AIR CLEANER |
FIGURE 3.4 | COVER |
b.Refer to engine owner's manual for cleaning and service instructions. Remove and clean engine air
AIR PRE-
CLEANER
AIR CLEANER
c.Reinstall air cleaner cover. Insert tabs located at the bottom of the cover into corresponding slots in engine cover. Position cover and engage latch over cover and rotate and push down to lock.
3.3.2.MOWER COMPONENTS
1. Mower Drive Belt
Check belt for proper tension. No adjustment required. Replace belt as needed.
2. Mower Blade
Check blade for sharpness, wear, damage, and torque. See the section on Mower Blade Replacement/Repair.
3. Mower Deck Levelness
Check mower deck for proper levelness. Adjust as required. See section on Mower Deck Adjustment - Levelness.
WARNING
Lifting or letting down the machine unassisted can cause severe injury. Always have assistance from another person when supporting the weight of machine.
4.Cleaning Mower Deck
a.Make sure fuel cap is on tight. Start engine and allow it to run until engine runs out of fuel. Close vent on fuel filler cap. See Figure 2.3.
b.Remove key from ignition switch.
c.Remove spark plug wire(s) and secure away from spark plug(s).
d.Carefully stand YARD CRUISER on rear bumper.
e.Clean underside of mower deck, removing all accumulation of grass clippings and debris.
f.Lower YARD CRUISER to ground. Clean top of deck, removing all grass clippings and debris.
5.Mower Blade Spindle - Lubrication
a.Lubricate spindle bearings with three shots of general purpose grease from grease gun. See Figure 3.6.
TOP VIEW OF 48” DECK
LUBRICATE
SPINDLE
BEARINGS
FIGURE 3.5
FIGURE 3.6
13