Snapper Z-Mow / 150Z Specifications

Specifications

Make Briggs & Stratton

Model Intek

Horsepower 18.5 @ 3600 rpm

Displacement 30.59 Cu.in (501 cc)

Electrical System 12 Volt, 16 amp.Alternator, Battery: 230 CCA

Oil Capacity 48 Oz. (1.4 L)

Fuel Tank Cap. Capacity: 1.65 Gallons (6,25 L)

Rear Wheels Tire Size:18 x 8.50-8

Inflation Pressure:615 psi (1,03 bar)

Front Wheels Tire Size: 11 x 4.00-5

Inflation Press.:40 psi (2,76 bar)

Type EZT

Hydraulic Fluid Sealed Unit

Capacity 2.6 qt (2,5 L)

Speeds Forward:0-5.5 MPH (0-8,8 km/h)

@ Specified rpm Reverse: 0-3.5 MPH (0-5,6 km/h)

Continuous Torque 115 ft. lbs. (155 N.m.)

Output

Maximum Weight 340 lbs.(154 Kg)

on Axle

Overall Length 66” (167,64 cm)

Overall Width 52”(132,1 cm)

Height At Top of Seat:45” (114,3 cm)

Weight (approx.) 550 lbs. (249 kg)

NOTE:Specifications are correct at time of pr inting and are subject to change without notice.

* The power ratings for an individual engine model are initially developed by starting with SAE (Society of Automotive

Engineers) code J1940 (Small Engine Power & Torque Rating Procedure) (Revision 2002–05). Given both the wide

array of products on which our engines are placed, and the variety of environmental issues applicable to operating the

equipment, it may be that the engine you have purchased will not develop the rated horsepower when used in a piece

of power equipment (actual “on–site”power). This difference is due to a variety of factors including, but not limited to,

the following:differences in altitude, temperature, barometric pressure, humidity, fuel, engine lubrication, maximum

governed engine speed, individual engine to engine variability, design of the particular piece of power equipment, the

manner in which the engine is operated, engine run–in to reduce friction and clean out of combustion chambers,

adjustments to the valves and carburetor, and other factors.The power ratings may also be adjusted based on com-

parisons to other similar engines utilized in similar applications, and will therefore not necessarily match the values

derived using the foregoing codes.