Snapper ZT20501BV, ZT19441KWV Operation, General Operating Safety, Checks Before Starting

Operation

GENERAL OPERATING SAFETY

Before first time operation:

•Be sure to read all information in the Safety and Operation sections before attempting to operate this tractor and mower.

•Become familiar with all of the controls and how to stop the unit.

•Drive in an open area without mowing to become accustomed to the unit.brake pedal or set the parking brake.

CHECKS BEFORE STARTING

•Check that crankcase is filled to full mark on dipstick. See the engine Operator’s Manual for instructions and oil recommendations.

•Make sure all nuts, bolts, screws and pins are in place and tight.

•Adjust the seat position, and make certain you can reach all controls from operator’s position.

•Fill the fuel tank with fresh fuel. Refer to engine man- ual for fuel recommendations.

WARNING

Never operate on slopes greater than 17.6 percent (10°) which is a rise of 3-1/2 feet (106 cm) vertically in 20 feet (607 cm) horizontally.

Select slow ground speed before driving onto a slope. Use extra caution when operating on slopes with a rear-mounted grass catcher.

Mow across the face of slopes, not up and down,use caution when changing directions and

DO NOT START OR STOP ON SLOPE.

WARNING

Never allow passengers to ride on the unit. Before leaving the operator’s position for any reason, engage the parking brake, disengage the PTO, stop the engine and remove the key.

To reduce fire hazard, keep the engine, tractor and mower free of grass, leaves and excess grease. Do not stop or park tractor over dry leaves, grass or combustible materials.

Gasoline is highly flammable and must be handled with care. Never fill the tank when the engine is still hot from recent operation. Do not allow open flame, smoking or matches in the area. Avoid over-filling and wipe up any spills.

A

C

B

Figure 1. Pre-Start Checks

A.Fuel Tank Cap

B.Crankcase Oil Fill

C.Seat Adjustment Lever

WARNING

Do not load this zero-turn rider on a trailer or truck using two separate ramps. Only use a single ramp that is at least one foot wider than the width of the rear wheels of this rider. This rider has a zero turning radius and the rear wheels could fall off the ramps, or the rider could tip over injuring the operator or bystanders.

8