English
1166
3.6 Switching point programming Four switching points can be set in the Basic Terminal 3010.
The switching points are used for switching and dosing.
Setting the switching points
Press the switching point key.
The first switching point is displayed. This is indicated by the arrow in the
display.
Set the value using the arrow keys ( / ). The value is incremented
individually by tapping the key briefly. When you hold the key down, the
display increments or decrements continuously.
Acknowledge by pressing the -key.
The display jumps to the next switching point.
Set the value using the arrow keys ( / ).
Press the -key to confirm, etc.
Each switching point function is defined in Setting mode (see separate
description 470.702.078 User Mode).
3.7 Checking The switching points for the internal LED lamps or the external lamps (optio-
nal) are used for checking.
Enter the setpoints as check values as follows.
Enter the switching points as described in 3.6.
Activate in Setting mode (470.702.078 User Mode).
3.8 Dosing The following dosing functions can be set:
• Coarse dosing without correction value
+ fine dosing without correction value
• Coarse dosing with correction value + fine dosing with correction value
• Coarse dosing without correction value + fine dosing with correction value
• Fine dosing without correction value
• Fine dosing with correction value
Switching point Value
S1 0
S2 Lower tolerance
S3 Upper tolerance
S4 Upper tolerance
Ba_3010_GB.qxd 03.04.2008 17:07 Seite 16