16 CHAPTER 1: INTRODUCING THE SWITCH 5500 FAMILY

Figure 7 Switch 5500G-EI (48 port) — front view

Figure 8 Switch 5500G-EI SFP (24 port) — front view

WARNING: The RJ-45 ports are shielded RJ-45 data sockets. You cannot use them as standard traditional telephone sockets, or to connect the unit to a traditional PBX or public telephone network. Only connect RJ-45 data connectors, network telephony systems, or network telephones to these sockets. You can connect either shielded or unshielded data cables with shielded or unshielded jacks to these data sockets.10BASE-T/ 100BASE-TX/ 1000BASE-T PortsThe 10BASE-T/100BASE-TX/1000BASE-T ports have RJ-45 connectors and are configured as Auto MDIX (cross-over).The default state for these ports is auto-negotiation enabled, where the link’s speed, duplex, and flow control modes are automatically detected to provide the highest available bandwidth with the link partner.
10/100/1000BASE-T Ports
Console Port
SuperStack4Switch5500G-EI 48-port
Port Status LEDs
Unit LED
45 46 47 48
Dual Personality
10/100/1000BASE-T/
1000BASE-X SFP Ports
1 432 5 678 9 10 11 1213 161514 17 18 19 20 21 22 23 24 25 282726 29 30 31 32 33 34 35 3637 403938 41 42 43 44 45 46 47 48
Status:Green=10MbpsYellow=10MbpsFlashing=DisabledPacket:Green=Full Duplex Yellow=Half Duplex Power:Green=DeliveringPower Yellow=Fault Flashing Green=Over BudgetPWRRPSMODSTK100%80%60%40%20%Mode:Green=StatusYellow=PacketRed=POE
Stack
LED
Mode LED
Power LED
RPS LED
Module LED
Unit LEDConsole Port10/100/1000BASE-TX PortsPort Status LEDs1000BASE-X Ports
1
13
3CR17259-91SuperStack 4 Switch 5500G-EI SFP 24-PortPWRRPSMODSTK
11
23
10
22
8
20
7
19 12
24
9
21
6
18
5
17
4
16
3
15
2
14
1000BASE-X:
Green=1000Mbps Flashing Yellow=POST failed
10/100/1000BASE-TX:
S(Speed):Green=1000Mbps Yellow=10/100Mbps
D(Duplex):Green=Full Duplex Yellow=Half Duplex
ModeLEDStackLEDRPS LEDPower LED10/100/1000Base-TX1000Base-X1000Base-X
SD
25/11
SD
26/12
SD
27/23
SD
28/24
10014925-AD_S5500_GSG.book Page 16 Thursday, August 16, 2007 12:29 PM