Operation
PLEASE READ ALL INSTRUCTIONS BEFORE OPERATING HEATER!
1.Make sure the Temperature Control Knob is at the “DOT” position. [Fig 1]
Make sure the power switch is at the off position.
[Fig 2]
2.Plug the power cord into a suitable electrical outlet. [Rated not less than 115 volt].
3.Turn the power switch to the “ON” position. Adjust the Temperature Control Knob clockwise until the Red Light Indicator turns on [Fig 2]. The Temperature Control should begin.
Note: The Red Light Indicator will turn off when the room reaches the desired temperature. After a while, as the room temperature falls, the heater will turn on again and release heat until the room temperature rises to the desired temperature. Desired room temperature is maintained automatically by this procedure.
You can adjust the temperature control knob to increase or decrease the room temperature as desired by turning the knob clockwise or
8
