Installation
Required Tools for Floor Use:
Phillips screwdriver (not supplied)
Estimated Assembly Time for Floor Use: 1 minute
Assembly Instructions for Floor Use:
Insert the feet and bolts onto the unit as shown in the diagram.
Required Tools for Wall Mounting:
Phillips screwdriver (not supplied), Drill (not supplied), Hammer (not supplied)
Mounting Instructions:
STEP 1
Using the mounting support as a guide, mark the first screw hole on the wall.
STEP 2
Move the mounting support, and drill the first screw hole.
STEP 3
Insert the first mounting anchor into the drilled hole.
STEP 4
Place the mounting support on the wall. Insert a screw through the mounting support and anchor. Tighten the screw lightly.
STEP 5
Use the other side of the mounting support to mark the second screw hole on the wall [approximately 5 7/16 in.].
STEP 6
Move the mounting support, and drill the second hole.
STEP 7
Insert the second mounting anchor into the drilled hole.
STEP 8
Place the mounting support on the wall. Insert the second screw through the mounting support and anchor. Firmly tighten both screws.
STEP 9
After mounting the heater, insert two screws into the bottom holes and secure to wall for safety purposes.
6
