OPERATING INSTRUCTIONS
CONTROL PANEL
1.Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet. Only operate heater in upright position with caster wheels attached.
2.Turn on the heater and select a heat setting:
On the control panel, turn the POWER SELECT dial to the desired setting: LOW (750W), HIGH (1500W).
3.Adjust the thermostat by turning the THERMOSTAT dial on the control panel. You will hear a faint click noise when the thermostat is turned to a point above the current room temperature. Continue to turn the thermostat to increase the room temperature. If the area becomes too warm turn the THERMOSTAT dial down slightly until you reach a point where the temperature is more comfortable.
4.Once you have chosen the desired temperature, the heater will remain on until the room temperature increases to the temperature set on the THERMOSTAT dial. The heater will cycle on and off to maintain the desired room temperature. The power indication light will cycle on and off with the heater. When the heater is in heating mode, the light will turn on. When the heater is in standby mode, the light will turn off.
5.Unplug the heater when not in use.
POWER INDICATION
LIGHT
POWER SELECT DIAL
THERMOSTAT DIAL
7
