INSTALLING THE GRAVITY DRAIN HOSE
CARE AND MAINTENANCE
Option 2: GRAVITY DRAIN HOSE
Step 1: Open the drain connector door. (Fig. 6)
(FIG. 6)
Step 2: Install and secure the drainage joint onto the drain connector. (Fig. 7)
CLEANING THE AIR FILTER
After 250 hours of operation the FILTER RESET indicator will light up to remind you to clean and change the air filter.
It is recommended to periodically check the filter for excess dirt even if the FILTER RESET indicator is off.
1.To remove the air filter, press the two filter tabs and pull the filter holder away from the back of the unit.
2.Remove the filter and clean with warm,
soapy water. Rinse and allow the filter to dry before placing back in the unit.
3.Place the filter back into dehumidifier. Plug unit back into outlet, power the unit on and press and hold the FILTER key up to 5 seconds on the control panel to reset the filter setting.
NOTE: DO NOT place the filter in a dish- washer
CAUTION: DO NOT operate the dehumidi- fier without a filter. Doing so may cause a unit failure.
WARNING
•Disconnect power supply cord from re- ceptacle before performing any mainte- nance.
CLEANING THE EXTERIOR
Clean the cabinet using a damp cloth and a mild detergent. Do not use bleach or abra- sives.
CONTROL PANEL
Wipe down the control panel with a dry cloth.
CLEANING THE BUCKET
Every few weeks, clean the dehumidifier bucket. Partially fill the bucket with clean water and mild detergent. Swish the mixture around in the bucket, empty and rinse. Re- place the bucket when finished
NOTE: Do not place the bucket in a dish- washer.
(FIG. 7)
Step3: Place large hose clamp on the flat end of the dehumidifier drain hose. (Fig.8)
(FIG. 8)
FILTER TABS
8 | 13 |
