Soleus Air SG-WAC-12ESE-C, SG-WAC-10ESE-C manual Electrical Requirements, Recommended Ground Method

ELECTRICAL REQUIREMENTS

Electrical Shock Hazard

Plug into a grounded 3 prong outlet. Do not remove the ground prong. Do not use an adapter

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock

Recommended Ground Method

The electrical ratings for your air conditioner are listed on the model and serial number label located on the front left side of the unit (when facing the front).

Specific electrical requirements are listed in the chart below. Follow the requirements below for the type of plug on the power supply cord.

Wiring Requirements Power Supply Cord

•115 volt (103.5 min.—126.5 max)

•0-12 amps

•15-amp time-delay fuse or circuit breaker

•Use on single outlet circuit only

For your personal safety, this air conditioner must be grounded. This air conditioner is equipped with a 3 prong power supply cord with a grounded plug. To minimize the possibility of electrical shock, the cord must be plugged into a 3 prong outlet and grounded in accordance with all local codes and ordinances. If a 3 prong outlet is not available, it is the cus- tomer’s responsibility to have a properly grounded 3 prong outlet installed by a qualified electrician.

It is the customer’s responsibility:	Copies of the standards listed may be obtained from:
• To contact a qualified electrician	National Fire Protection Association
• To assure that the electrical installation is adequate	One Batterymarch Park
	Quincy, Massachusetts 02269
and in conformance with the National Electrical Code,
ANSI/NFPA 70 - latest edition, and all local codes and
ordinances.
LCDI Power Cord and Plug

This air conditioner is equipped with an LCDI (Leakage Current Detection and Interruption) power cord that is required by UL. This power supply cord contains state-of-the-art electronics that sense leakage current. If the cord is damaged and leakage occurs, power will be disconnected from the unit.

The test and reset buttons on the LCDI Plug are used to check if the plug is functioning properly. To test the plug:

1.Plug power cord into a grounded 3 prong outlet

2.Press RESET (on some units a green light will turn on).

3.Press the TEST Button, the circuit should trip and cut all power to the air conditioner (on some units a green light may turn off.

4.Press the RESET button for use. You will hear a click and the A/C is not ready for use.

NOTES:

•The RESET button must be engaged for proper use.

•The power supply cord must be replaced if it fails to trip when the TEST button is pressed and the unit fails to reset.

•Do not use the power supply cord as an ON/OFF switch. The power supply cord is designed as a protection device.

•A damaged power supply cord must be replaced with a new power supply cord from Soleus Air Powered by Gree.

•The power supply cord contains new user serviceable parts. Opening the tamper-resistant case voids all warranty and per- formance claims.

NOTE: Your units power cord and plug may differ from the one shown.

3