Solid State Logic XR622 owner manual Default MIDI Controller Mapping, Level Compensation, Page F-3

X-Rack Master Module

•Use the D-Pot to select ‘le’ (MIDI Remote Learn) and press SAVE to enable learn mode.

•Operate any one of the ‘soft’ controls on the XR622 Master module. This will cause the LED of the selected control to flash (the ‘SEL’ LED will flash if either of the potentiomenters have been chosen). Assign a MIDI controller to the selected function by operating the required MIDI controller. Repeat the ‘operate – assign’ process for all required controls.

•Press the D-Pot again to leave this option and return to the setup menu or press and hold SETUP/MIDI until the SETUP/MIDI LED stops flashing to return to normal operation.

•Switch assignments can be reset to the system defaults by pressing COPY/DEL when in MIDI Remote Learn mode; the ‘Empty’ LED indicating when the assignments have been deleted.

Default MIDI Controller Mapping
MIDI Controller	Master Module Control
1	MIX
2	REC
3	EXT
4	ALT
5	MONO
6	DIM
7	CUT
8	AFL Level
9	Monitor LEVEL

Note. These configuration options are also covered in the main X-Rack manual.

Level Compensation

Each of the Insert Send, Mix Bus, Record Bus and Monitor outputs are provided with level compensation for driving low (600Ω) inputs. Level compensation is activated by removing a jumper for each output as follows:

600Ω Output Level Compensation
Link	Output
LK1	Alt/Main Monitor Right
LK2	Record Bus Left
LK3	Record Bus Right
LK4	Alt/Main Monitor Left
LK5	Insert Send Left
LK6	Insert Send Right
LK7	Mix Bus Left
LK8	Mix Bus Right

Page F-3