Sonance THINLINETM SONANCE THINLINE TL and SSTR, F i g u r e 6 I n s e r t S p e a k e r, Clamps

SONANCE THINLINE™ TL and SSTR

(Stray strands that touch each other can cause a short-circuit that can damage your amplifier.)

4.The speaker’s connector posts are spring-loaded. Push the top of each connector post down to open the connector and insert the exposed wires into the holes in the posts.

(The TL623SSTR has connectors for both the left and right channels.)

• The speaker’s positive post is labeled with a red dot; the negative post is labeled with

ablack dot. Double-check that you connected amplifier “+” to speaker “+” and amplifier “–” to speaker “–”.

5.Make sure all the RotoLock clamps are in the full clockwise position so that they are tucked within the mounting hole’s border. Insert the speaker into the hole in the ceiling (Figure 6). The RotoLock system can accommodate a maximum ceiling material thickness of 1¼”.

•The FastMount tabs will prevent the speaker from falling out of the mounting hole, allowing

the installer to let go of the speaker to pick-up tools or other items (Figure 7).

NOTE: THE FASTMOUNT TABS ARE DESIGNED FOR ONE-TIME USE ONLY. IF THE SPEAKER IS REMOVED FROM THE MOUNTING HOLE THE FASTMOUNT TABS WILL DISCONNECT AND REMAIN INSIDE THE CEILING .

6. Tighten the four screws on the front of the speaker baffle. The RotoLock clamps will automatically rotate into position and begin clamping the speaker (Figure 8).

• When you notice resistance on the screws the speaker has been clamped successfully.

NOTE: THE SPEAKER FLANGE IS DESIGNED TO FLEX AND CONFORM TO ANY SMALL IMPERFECTIONS IN THE CEILING SURFACE. DO NOT TIGHTEN THE SCREWS SO MUCH SO THAT THE FLANGE BOWS-OUT.

I M P O RTA N T : A l wa y s u s e l o w - t o r q u e s e t t i n g s ; N E V E R over-tighten.

7.Attach the grille after the speaker has been installed. Insert about half of the grille into the groove at the edge of the speaker. Gently fit the remaining half of the grille by work-

ing around the speaker, fitting the grille into the groove as you go.

NOTE: YOU CAN ADJUST THE TORQUE APPLIED TO THE ROTOLOCK SCREWS TO ACHIEVE A PROPER GRILLE FIT.

F i g u r e 6 : I n s e r t S p e a k e r

I n t o M o u n t i n g H o l e

FastMount®

Tabs

F i g u r e	7 :
F a s t M o u n t ® T a b s
RotoLock®
Clamps
F i g u r e	8 :
R o t o L o c k ® C l a m p s

8