Sony 100 To change the date and time, When turning on the power, To turn off the power, Power Save (The camera nearly shuts down if it is not operated)

To change the date and time

Select [Date/Time set] in the Setup menu and perform the procedure in step 2-2 to -4.

t“User’s Guide/Troubleshooting” (page 99)

When turning on the power

• Unless you set the clock, “Set date and time?” appears each time the camera is turned on.

To turn off the power

Set the POWER switch to OFF sliding in the arrow direction. Attach the lens cap. After you remove the lens, store the camera with the body cap attached.

Power Save (The camera nearly shuts down if it is not operated)

If you do not operate the camera for about five seconds, the recording mode display on the LCD monitor disappears. Also, if you do not operate the camera for about three minutes, the camera turns to power saving mode and nearly shuts down (Power Save). To cancel the power save, operate the camera, for example, by pressing the shutter button halfway down.

•You can change the time that must elapse to activate the function (the default settings are [5 sec.]/[3 min.]). t“User’s Guide/Troubleshooting” (page 102)

Changing the language setting

You can change the screen display to show messages in a specified language. To change the language setting, follow the procedure below.

1Press MENU to display the menu.

2Select [] with the controller, then press the center of the controller.

3 Select [ Language] with v/V on the contoroller, then press B.

4Select the desired language with v/V on the contoroller, then press the center of the controller.

9