SHOT TRANS

Select this setting to set the transition time and curve. See page 42 for details on using the shot transition function.

xTRANS TIME

Select transition time ([3.5 sec] to [15.0 sec] seconds, the default setting is [4 sec]).

xTRANS CURVE

Select the transition curve. The transition curve changes as follows.

*1: parameter level

*2: transition of time

LINEAR

Make the transition linearly.

*1

*2

BSOFT STOP

Make the transition slowly at the end.

*1

*2

SOFT TRANS

Make the transition slowly at the beginning and end, and linearly in between.

*1

*2

bNote

•You cannot change [TRANS TIME] and [TRANS CURVE] settings during store, check, or execution of [SHOT TRANS]. Cancel [SHOT TRANS] setting by pressing the

ASSIGN button 1 several times before changing [TRANS TIME] or [TRANS CURVE] setting.

DV FRAME REC

You can record pictures with a stop-motion animated effect by alternately recording a few frames and then moving the subject a little. Operate your camcorder using the Remote Commander to prevent camera shake.

B OFF

Select to record in the standard recording

 

mode.

 

ON ( )

 

 

Select to record pictures using the DV

 

Using

1 Select [ON] by the SEL/PUSH EXEC

FRAME REC function.

 

dial.

the

2 Press the MENU button to hide the

Menu

menu screen.

 

3 Press the REC START/STOP button.

 

A picture (approximately 5 frames) is

 

recorded, and your camcorder enters

 

the standby mode.

 

4 Move the subject and repeat step 3.

 

bNote

•When you use frame recording continuously, the remaining tape time will not be indicated correctly.

•The last scene will be longer than other scenes.

•You cannot record index signals during frame recording.

•This is automatically set to [OFF] if you turn the power off and back on.

BACK LIGHT

When you set [BACK LIGHT] to [ON], . is displayed and the back light function is enabled (the default setting is [OFF]).

bNotes

•The back light function is canceled when you set [SPOTLIGHT] to [ON].

Continued , 59