Sony 3-298-969-11(1) 32 GB, AFT, LNA, B/G:, D/K:, Skip, Label, Preset, RETURN, PROG +/–, Audio Filter, System/Channel, Manual Programme, If you know the channel number (frequency)

Manual Programme Press F/f to select the programme number you want to manually tune (if tuning a

Preset	recorder, select channel 00), then press .
	System/Channel 1 Press F/f to select “System”, then press .

2Press F/f to select one of the following TV broadcast systems, then press RETURN.

B/G: For western European countries/areas

I:For the United Kingdom

D/K: For eastern European countries/areas

L:For France

3Press F/f to select “Channel”, then press .

4Press F/f to select “S” (for cable channels) or “C” (for terrestrial channels), then press g.

~

•“S” is not available when “United Kingdom” is selected for “Country” (page 7).

5Tune the channels as follows:

If you do not know the channel number (frequency)

Press F/f to search for the next available channel. The search stops when a channel is found. To continue searching, press F/f.

If you know the channel number (frequency)

Press the number buttons to enter the channel number of the broadcast you want to tune, or the channel number of your recorder.

6Press to jump to “Confirm”, then press .

Repeat the above procedure to preset other channels manually.

Label	Assigns a name of your choice, up to five letters or numbers,
	to the selected channel. This name appears briefly on the
	screen when you select the channel.
AFT	Allows you to fine-tune the selected channel manually if you
	feel that a slight tuning adjustment may improve picture
	quality.
	You can adjust the fine tuning over a range of –15 to +15.
	When “On” is selected, fine tuning adjustments are made
	automatically.
Audio Filter	Improves the sound of individual channels when distortion
	occurs in mono broadcasts. Sometimes a non-standard
	broadcast signal can cause sound distortion or intermittent
	sound muting in mono programmes.
	If you do not experience any sound distortion, we recommend
	that you leave this option to “Off” (factory setting).
	~
	• You cannot receive stereo or dual sound when “Low” or
	“High” is selected.
	• “Audio Filter” is not available when “System” is set to “L”.
LNA	Improves the picture quality of the channel (noisy picture)
	when the broadcast signal is very weak.
	If you cannot see any improvement in the picture quality even
	if you set to “On”, set this option to “Off” (factory setting).
Skip	Skips unused analogue channels when you press PROG +/–
	to select channels. To select channels you have programmed
	to skip, use the corresponding number buttons.

32 GB