Install the Universal Wall Fitting

English

Four quick steps to install and get maximum performance from the Polaris 480 PRO:

•Install the Universal Wall Fitting (UWF) with Quick Disconnect

•Adjust feed hose to fit pool length

•Assemble the cleaner

•Check for proper wheel RPM (revolutions per minute)

1	Install the Universal Wall Fitting
1	Installs in minutes on pools with a dedicated cleaner return line and a threaded 1-1/2” female

	pipe fitting.
	1. Turn on the filtration pump and flush out the plumbing line.Turn pump off.
	2. Remove the UWF from the Quick Disconnect and screw it into the return opening.
	3. Turn the Quick Disconnect clockwise into the UWF and pull away to secure.
	Dedicated return Line
	Universal
	Wall Fitting
	Quick
	Disconnect
	Pressure Relief
	Valve
	Adjust Feed Hose To Fit Pool Length
	With the hose connected to the pool wall at the return line, extend hose to the farthest point
	on the pool. The hose end must be within 6" of this point – longer or shorter – shown by the
2 dotted circle.
	Hose too long? Cut excess length from first hose section and reconnect hose sections.
	Hose too short? Buy an additional feed hose section (part #9-100-3104), one swivel (part
	#D20) and two hose nuts (part #D15) from an authorized Polaris dealer.
	After adjusting proper hose length, position the hose floats as shown.
	In-Line
	Filter
	First Hose Section
	Dedicated
	Return Line
	Floats evenly distributed	Leader hose floats
	1-1/2 to 3 feet apart	Leader hose floats
		2-3 feet apart

Sony 480 owner manual Install the Universal Wall Fitting, Adjust Feed Hose To Fit Pool Length