6
Setting up your TV
Some TV models are packaged with a
detached Table-Top Stand so you can mount
your TV to a wall right away. If you are not
mounting the TV to a wall, you will need to
attach the Table-Top Stand. You will need a
Phillips screwdriver and the supplied screws
to complete the task. Look for the attachment
instructions provided with the TV.
Be sure to consider the following while
setting up your TV:
Disconnect all cables when carrying the
TV.
Carry the TV with the adequate number
of people; larger size TVs require two or
more people.
Correct hand placement while carrying
the TV is very important for safety and
to avoid damage.
Ensure your TV has adequate
ventilation, see page 16.
For best picture quality, do not expose the
screen to direct illumination or sunlight.
Avoid installing the TV in a room with
reflective wall and floor materials.
If the TV is brought directly from a cold
to a warm location, or is placed in a very
damp room, or is placed in a room in
which heating has just been turned on,
moisture may condense on the surface or
inside the TV. Should this occur, turn off
the TV and leave the TV off until the
moisture evaporates, and then the TV
can be used. If you notice moisture
condensation between the glass panel
and the LCD, turn on the TV and the
condensation will evaporate after the TV
has warmed up.

Attaching the Table-Top

Stand

Refer to the supplied Table-Top Stand
instruction leaflet for proper attachment for
some TV models.
~
Do not put stress on the LCD panel or the
frame around the screen.
Be careful to not pinch your hands or the AC
power cord when you install the TV unit to the
Table-Top Stand.
For KDL-52/46NX800 and KDL-46/
40NX700
1Gently slide the TV unit onto the
Table-Top Stand and align the screw
holes.
2Use the supplied screws to attach the
TV unit to the Table-Top Stand.
~
If you use an electric screwdriver, set the
tightening torque at approximately 1.5 N·m
{15 kgf·cm}.