F:\SD0004_A1L\FINAL\4261827311_GB\42618

27311\4261827311_GB\GB_020WAR.fm

master page=right

specdef20090918
BDP-S280

4-261-827-31(1)

3
For more detailed information about recycling of this
product or battery, please contact your local Civic
Office, your household waste disposal service or the
shop where you purchased the product.
The manufacturer of this product is Sony Corporation,
1-7-1 Konan Minato-ku Tokyo, 108-0075 Japan. The
Authorised Representative for EMC and product safety
is Sony Deutschland GmbH, Hedelfinger Strasse 61,
70327 Stuttgart, Germany. For any service or guarantee
matters please refer to the addresses given in separate
service or guarantee documents.

Precautions

• This unit operates on 220–240V AC, 5 0/60Hz. Check
that the unit’s operating voltage is identical with your
local power supply.
• To prevent fire or shock hazard, do not place objects
filled with liquids, such as vases, on the apparatus.
• Install this unit so that the mains lead can be
unplugged from the wall socket immediately in the
event of trouble.
Precautions
This equipment has been tested and found to
comply with the limits set out in the EMC Directive
using a connection cable shorter than 3 metres.

On placement

• Place the player in a location with adequate
ventilation to prevent heat build-up in the player.
• Do not place the player on a soft surface such as
a rug that might block the ventilation holes.
• Do not install this player in a c onfined space, such
as a bookshelf or similar unit.
• Do not place the player in a location near heat
sources, or in a place subject to direct sunlight,
excessive dust, or mechanical shock.
• Do not place the player outdoors, in vehicles, on
ships, or on other vessels.
• If the player is brought directly from a cold to a
warm location, or is placed in a very damp room,
moisture may condense on the lenses inside the
player. Should this occur, the player may not
operate properly. In this case, remove the disc and
leave the player turned on for about half an hour
until the moisture evaporates.
• Do not install the player in an inclined position. It
is designed to be operated in a horizontal position
only.
• This player should be installed and opera ted with
a minimum distance of at least 20 cm or more
between the player and a person’s body
(excluding extremities: hands, wrists, feet and
ankles).
• Do not place heavy or unstable objects on the
player.
• Do not place any objects other than discs on the
disc tray. Doing so may cause damage to the
player or the object.
• Take out any discs when you move the player. If
you don’t, the disc may be damaged.
• Disconnect the AC power cord (mains lead) and
all other cables from the player when you move
the player.

On power sources

• The player is not disconnected from the AC
power source (mains) as long as it is connected to
the wall outlet, even if the player itself has been
turned off.
• Disconnect the player from the wall outlet if you
are not going to use the player for a long time. To
disconnect the AC power cord (mains lead), grasp
the plug itself; never pull the cord.
• Observe following points to prevent the AC
power cord (mains lead) being damaged. Do not
use the AC power cord (mains lead) if it is
damaged, as doing so may result in an electric
shock or fire.
–Do not pinch the AC power cord (mains lead)
between the player and wall, shelf, etc.
–Do not put anything heavy on the AC power
cord (mains lead) or pull on the AC power cord
(mains lead) itself.

On adjusting volume

Do not turn up the volume while listening to a
section with very low level inputs or no audio
signals. If you do, your ears and the speakers may
be damaged when a peak level section is played.

On cleaning

Clean the cabinet, panel, and controls with a soft
cloth. Do not use any type of abrasive pad, scouring
powder or solvent such as alcohol or benzine.

On cleaning discs, disc/lens cleaners

Do not use cleaning discs or disc/lens cleaners
(including wet or spray types). These may cause the
apparatus to malfunction.

On replacement of parts

In the events that this player is repaired, repaired
parts may be collected for reuse or recycling
purposes.

On connecting to the HDMI OUT jack

Observe the following as improper handling may
damage the HDMI OUT jack and the connector.
• Carefully align the HDMI OUT jack on the rear
of the player and the HDMI connector by
checking their shapes. Make sure the connector is
not upside down or tilted.
,continued