23
Control Panel
Chapter 2 Locations and Functions of Parts
eCLEAR button
x When menu mode is selected
When this button is pressed, the last two digits of the menu
page reset to “00.”
x When CAM mode is selected
When this button is pressed, the camera position number
displayed on the display panel disappears.
x When SW mode is selected
When this button is pressed, the snapshot, direct wipe, or
direct PIP number displayed on the display panel
disappears.
fNumeric buttons 0 to 9 and . (dot) button
x When menu mode is selected
Use the numeric buttons and . (dot) button to enter menu
page.
For procedures for menu page input, see “To display the
menu” on page 22.
x When CAM mode is selected
Use numeric buttons 0 to 9 to enter the camera position
number.
x When SW mode is selected
Use numeric buttons 0 to 9 to enter the snapshot, direct
wipe, or direct PIP number.
To enter the two-digit number, press the second-digit
number then the first-digit number.
To correct a number entered, press the CLEAR button then
enter the correct number.
6 Display Panel / Camera/Switcher/Menu Control Section
The buttons and controls in this section differ in function
depending on whether the switcher is in CAM mode, in
SW mode or in menu mode.
aDisplay panel
Displays the menu, the current effect, and the camera
settings.
While viewing the display panel, you can check and
change the settings.
When the menu of a lower layer has further lower layers,
the menu name is followed by “..”
The following display panel shows a representative
example:
Menu layers in menu mode
Note
NEAR FAR
EXIT
PAGE
FOCUS BRIGHT ZOOM PAN/TILT
F1 F2 F3 F4
1Display panel
2Adjustment controls
3EXIT button
4PAGE button
SETUP
INPUT
NAME..
FS..
ASSIGH..
SIDE..
ADJUST.. 1/1
920
PROC..
Higher menu layer
Current displayed menu layer
Lower menu layer Page number
Menu page
INPUT
ADJUST
XPT BTN
3
Y-LEVEL
1.00
SETUP
0.0
3/6
923
C-LEVEL
1.00
Current displayed
menu layer
Menu pageSetting values
Higher menu layer Setting items Page number