Returning to a pre-registered position

– CCD-TRV99 only

Using the Remote Commander, you can easily go back to the desired point on a tape after playback. Use the tape counter. If the RC time code appears, set COUNTER to NORMAL in the menu system to display the tape counter.

(1) During playback, press COUNTER RESET at the point you later want to locate. The counter shows “0:00:00”.

(2) Press pwhen you want to stop playback.

(3) Press ZERO MEM on the Remote Commander. The ZERO MEM indicator flashes.

(4) Press 0to rewind or press )to fast-forward the tape to the counter’s zero point. The tape stops automatically when the counter reaches approximately zero.

COUNTER

0:00:00

 

 

1 RESET

3 ZERO MEM

0:12:34

 

 

 

 

ZERO MEM

operations Advanced

2 STOP

4 REW FF

Notes on the tape counter

•Something must be recorded on the tape in order for the tape counter to function. Tape counter does not work on a blank tape.

•There may be a discrepancy of several seconds from the actual time.

Notes on ZERO MEM

•When you press ZERO MEM, the counter’s zero point is memorized. Press ZERO MEM again before rewinding to cancel the memory.

•This function is cancelled automatically once the tape is rewound or advanced to the point you pre-registered.

•ZERO MEM does not function during recording or playing back.

71