WHITE (white balance automatic adjustment) button
Adjusts the white balance automatically when the WHITE/BLACK BALANCE switch is set to AUTO or PRESET. This button lights when adjustment starts, and flashes for eight seconds at an interval of about one second if adjustment is completed successfully. If adjustment could not be completed successfully, this button flashes for eight seconds at an intervals of about 0.5 seconds.
ATW (auto tracking white balance) button Press this button, lighting it, to adjust white balance automatically according to changes in lighting conditions.
Black balance adjustment knobs
Adjust the black level.
When the WHITE/BLACK BALANCE switch is set to MANUAL, the R knob adjust red components and the B knob adjusts blue components.
White balance adjustment knobs
Adjust the white level.
When the WHITE/BLACK BALANCE switch is set to MANUAL, the R knob adjust red components and the B knob adjusts blue components.
q; PHASE adjustment section
PHASE
H
H screw
SC switch
SC
I
SC screw
H (horizontal phase adjustment) screw
Use a screwdriver or other tool to adjust the horizontal phase difference between the output signal and an external sync signal.
SC (subcarrier phase adjustment) switch Adjust the subcarrier phase difference between the output signal and an external sync signal.
SC (subcarrier phase adjustment) screw After adjusting the subcarrier phase with the SC switch, use a screwdriver or other tool to make fine adjustments by rotating this screw.
qa CABLE COMP (cable compensation) adjustment section
CABLE COMP
SELECT | FINE |
| Y |
| C |
CABLE COMP buttons | CABLE COMP FINE screws |
CABLE COMP (cable compensation) buttons Use these button to adjust cable compensation for the length of the cable you are using. The internal cable compensation circuits prevent signal degradation by adjusting for the length of the cable. Settings are displayed in the SHUTTER SPEED/CABLE LENGTH display window (see page 20).
To change a setting, press the upper or lower button and keep it pressed for about one second. Then release the button and press it again within two seconds. Press and release the button quickly to display the current setting for two seconds.
Set to “L 25” for a cable 10 m (about 33 feet) or less in length.
CABLE COMP FINE (cable compensation fine adjustment) screws
Makes fine compensation adjustments to the video signal output from the VBS OUT connector. After using the CABLE COMP buttons to adjust for cable length, make fine adjustments by rotating these screws with a screwdriver or other tool. The Y screw adjusts the Y (luminance) signal, and the C screw adjusts the C (chroma) signals.
qs DIGITAL TRANSMISSION indicator
Lit in green: Digital signals are being transmitted from the camera/camcorder by CCZ cable or by BNC cable connected to the SDI IN connector.
Lit in red: The unit is in digital transmission mode, but there are no digital video signals being transmitted from the camera/camcorder.
Flashing in red: The unit is in digital transmission mode, but there are no digital or analog video signals being transmitted from the camera/ camcorder because the cables are not connected or because the camera/camcorder is powered off.
17