Sony CD-DH899N operation manual Listening to the iPod

Listening to the iPod

Supported iPod models:

●iPod nano (software 1.2 above)

●iPod mini (software 1.2 above)

●iPod (5th generation) (software 1.3 above) (Dock connector equipped Click Wheel model)

●iPod (4th generation) (software 3.0.2 above) (Dock connector equipped Click Wheel model)

●iPod nano (2nd generation) (software 1.0.0 above)

●iPod nano (3rd generation) (software 1.0.3 above)

●iPod nano (4th generation) (software 1.0.3 above)

●iPod classic (software 1.0.3 above)

●iPod touch (software 1.1 above)

●iPod touch (2nd generation) (software 2.1 above)

Caution:

Please update your iPod unit to the latest software version from Apple’s homepage before using it.

iPod adaptor connection

Notes:

●iPhone is not supported by this system.

●You can use an audio cable to connect your iPod to the AUDIO IN jack if:

1.your iPod adaptor does not fit into the iPod dock on the main unit.

2.you have an iPod that does not have an iPod adaptor.

3.you have an iPod that does not have an iPod 30 pin connector.

To insert iPod adaptor

1Press the ON/STAND-BY button to turn the power on.

2Insert the iPod adaptor into the iPod dock and connect your iPod.

		MINI COMPONENT SYSTEM
POWER
ON/STAND-BY	POWER	FUNCTION
	ON/STAND-BY
		VOL

CD

USB

TAPE

To remove iPod adaptor

Insert the tip of a screwdriver (“–” type, small) into the iPod adaptor hole as shown and lift upward to remove.

iPod (bottom)

Dock connector

iPod

To disconnect iPod

Simply remove the iPod from the iPod dock. It is safe to do so even during playback.

iPod adaptor (not supplied)

iPod dock

iPod connector

iPod playback

1Press the ON/STAND-BY button to turn the power on.

2Press the iPod button on the remote control or FUNCTION button repeatedly on the main unit to select iPod function.

3Insert iPod unit in iPod dock of main unit.

4Press the / button to start playback.

Notes:

●Once the iPod is connected to the unit it will begin charging.

●The iPod unit cannot be charged while the main unit is in the stand- by mode or during USB mode.

●Please make sure to set iPod unit to either NTSC or PAL to match your TV signal. Please visit Apple’s homepage for further information.

Navigating the iPod menus

1Press the MENU button to view the menu on iPod unit. Press it again to go back to previous menu.

2Use the TUNING ( or ) button on the remote control to select an item on the menu and then press ENTER button.

Note:

When navigating the iPod menus with remote control, do not operate any of the buttons on the iPod unit. The volume level is adjusted by pressing the VOL (+ or –) button on the main unit or the remote control. Adjusting the volume on the iPod unit gives no effect.

iPod operation:

The operations described below depend on the generation iPod you are using.

System on operation:

When the main unit is powered on, the iPod unit will automatically power on when docked in the unit (including TIMER function/exclude USB function).

System off (stand-by operation):

When the main unit is turned to stand-by mode, the docked iPod unit will automatically turn to stand-by mode.

E-4