Changing the output level

You can select the output level from the unit. Normally the unit is used in the initial output level; change the level if necessary.

1 Press (SHUF/REP) for two seconds.2 Press (SHUF/REP) momentarily.

Initial setting

3 Press or repeatedly to select the output level.

To decrease the output level

: ,

To increase the output level

: ,

4 Press (SHUF/REP) for two seconds.

Using on the wireless remote

1

Press (SHUF) for two seconds.

2

Press (SHUF) again momentarily.

3

Press

or

to select the

 

output level.

 

 

4 Press (SHUF) for two seconds.

Note

When you select level 4 or 5, the CD playback sound may be distorted or you may hear some noise. In such a case, select a lower output level on the unit and turn down the overall volume on your car audio.

Additional

Information

Precautions

•This unit cannot be used with a car audio without FM tuner.

•If your car was parked in direct sunlight resulting in a considerable rise in temperature inside the car, allow the unit to cool off before operating it.

•If no power is being supplied to the unit, check the connections first. If everything is in order, check the fuse.

•Avoid installing the CD changer, wireless remote, and wired remote in places:

—subject to temperature exceeding 55°C.

—subject to direct sunlight.

—near heat sources (such as heaters).

—exposed to rain or moisture.

—exposed to excessive dust or dirt.

—subject to excessive vibration.

If you have any questions or problems concerning your unit that are not covered in this manual, please consult your nearest Sony dealer.

Notes on compact discs

A dirty or defective disc may cause sound drop-outs during CD playback. To enjoy optimum sound, handle the disc as follows.

Handle the disc by its edge, and do not touch the unlabelled surface.

This way

Do not stick paper or tape on the discs.

Not this way

9