The following checklist will help you remedy the problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures.
General
Problem | Cause/Solution |
|
|
No sound. | •Rotate the dial in a clockwise direction to adjust the volume. |
| •Set the fader control to the center position for |
| systems. |
The contents of the memory have been erased.
•The power cord or battery has been disconnected. •The reset button has been pressed.
nStore the settings again into the memory.
Indications do not appear in the Remove the front panel and clean the connectors. See | |
display. | “Cleaning the connectors” (page 12) for details. |
|
|
No beep sound. | •An optional power amplifier is connected and you are not |
| using the |
| •The beep sound is canceled (page 10). |
CD playback
Problem | Cause/Solution |
|
|
CD cannot be loaded. | •Another CD is already loaded. |
| •The CD was forcibly inserted upside down. |
Play does not begin. | Dirty disc. |
|
|
CD is automatically ejected. | The ambient temperature exceeds 50°C. |
|
|
CD will not eject. | Press the 6button for two seconds. |
|
|
The operation buttons do not | Press the reset button. |
function. |
|
The sound skips due to | •The unit is installed at an angle of more than 60°. |
vibration. | •The unit is not installed in a sturdy part of the car. |
Radio reception
Problem | Cause/Solution |
|
|
Preset tuning is not possible. | •Memorise the correct frequency. |
| •The broadcast signal is too weak. |
|
|
Automatic tuning is not | The broadcast signal is too weak. |
possible. | nUse manual tuning. |
|
|
The “ST” indication flashes. | •Tune in the frequency accurately. |
| •The broadcast signal is too weak. |
| nSet to the MONO mode (page 9). |
|
|
14