Other functionsChanging the sound settingsAdjusting the sound characteristics — BAL/FAD/SUB

You can adjust the balance, fader, and subwoofer volume.

1Press the select button repeatedly until “BAL,” “FAD” or “SUB” appears.

The item changes as follows:

LOW*1 t MID*1 t HI*1 t

BAL (left-right) t FAD (front-rear) t SUB (subwoofer volume)*2 t AUX*3

*1 When EQ3 is activated (page 11).

*2 When the audio output is set to “SUB” (page 11).

“ATT” is displayed at the lowest setting, and can be adjusted up to 20 steps.

*3 When AUX source is activated (page 12).

2Rotate the volume control dial to adjust the selected item.

After 3 seconds, the setting is complete and the display returns to normal play/reception mode.

With the card remote commander

In step 2, to adjust the selected item, press <, M, , or m.

Customizing the equalizer curve— EQ3

“CUSTOM” of EQ3 allows you to make your own equalizer settings.

1Select a source, then press (EQ3) repeatedly to select “CUSTOM.”

2Press the select button repeatedly until “LOW,” “MID” or “HI” appears.

3Rotate the volume control dial to adjust the selected item.

The volume level is adjustable in 1 dB steps, from –10 dB to +10 dB.

Repeat steps 2 and 3 to adjust the equalizer curve.

To restore the factory-set equalizer curve, press and hold the select button before the setting is complete.

After 3 seconds, the setting is complete and the display returns to normal play/reception mode.

Tip

Other equalizer types are also adjustable.

With the card remote commander

In step 3, to adjust the selected item, press <, M, , or m.

Adjusting setup items — SET

1Press and hold the select button.

The setup display appears.

2Press the select button repeatedly until the desired item appears.

3Rotate the volume control dial to select the setting (example “ON” or “OFF”).

4Press and hold the select button.

The setup is complete and the display returns to normal play/reception mode.

Note

Displayed items will differ, depending on the source and setting.

With the card remote commander

In step 3, to select the setting, press < or ,.

The following items can be set (follow the page reference for details):

“z” indicates the default settings.

CLOCK-ADJ(Clock Adjust) (page 5)

CT (Clock Time)

To set “CT-ON” or “CT-OFF” (z) (page 9, 10).

BEEP

To set “BEEP-ON” (z) or “BEEP-OFF.”

AUX-A*1(AUX Audio)

To turn the AUX source display “AUX-A-ON” (z) or “AUX-A-OFF” (page 12).

SUB/REAR*1

To switch the audio output.

–“SUB-OUT” (z): to output to a subwoofer.

–“REAR-OUT”: to output to a power amplifier.

DIM (Dimmer)

To change the brightness of the display.

–“DIM-ON”: to dim the display.

–“DIM-OFF” (z): to deactivate the dimmer.

ILM (Illumination)

To change the illumination color: “ILM-1” (z) or “ILM-2.”

DEMO*1 (Demonstration)

To set “DEMO-ON” (z) or “DEMO-OFF”.

continue to next page t

11