Note

Be sure to create the ATRAC CD using authorized software, such as SonicStage 2.0 or later, or SonicStage Simple Burner 1.0 or 1.1.

If you have any questions or problems concerning your unit that are not covered in this manual, consult your nearest Sony dealer.

Cleaning the connectors

The unit may not function properly if the connectors between the unit and the front panel are not clean. In order to prevent this, detach the front panel (page 4) and clean the connectors with a cotton swab dipped in alcohol. Do not apply too much force. Otherwise, the connectors may be damaged.

Maintenance

Replacing the lithium battery of the card remote commander

Under normal conditions, the battery will last approximately 1 year. (The service life may be shorter, depending on the conditions of use.)

When the battery becomes weak, the range of the card remote commander becomes shorter. Replace the battery with a new CR2025 lithium battery. Use of any other battery may present a risk of fire or explosion.

+ side up

2 c 1

Notes on the lithium battery

Keep the lithium battery out of the reach of children. Should the battery be swallowed, immediately consult a doctor.

Wipe the battery with a dry cloth to assure a good contact.

Be sure to observe the correct polarity when installing the battery.

Do not hold the battery with metallic tweezers, otherwise a short-circuit may occur.

WARNING

Battery may explode if mistreated.

Do not recharge, disassemble, or dispose of in fire.

Fuse replacement When replacing the fuse, be sure to use one matching the amperage rating stated on the original fuse. If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. In such a case,

Main unit

Back of the front

 

panel

Notes

For safety, turn off the ignition before cleaning the connectors, and remove the key from the ignition switch.

Never touch the connectors directly with your fingers or with any metal device.

Removing the unit

1Remove the protection collar.

1Detach the front panel (page 4).

2Engage the release keys together with the protection collar.

Orient the release keys as shown.

3Pull out the release keys to remove the protection collar.

continue to next page t

consult your nearest Sony dealer.

Fuse (10A)

15