Sony CDX-GT200E Maintenance, Removing the unit, Cleaning the connectors, 2Remove the unit, 1Remove the protection collar

For details on ATRAC CD, see the SonicStage or SonicStage Simple Burner manual.

Note

Be sure to create the ATRAC CD using authorized software, such as SonicStage 2.0 or later, or SonicStage Simple Burner 1.0 or 1.1.

If you have any questions or problems concerning your unit that are not covered in this manual, consult your nearest Sony dealer.

Maintenance

Fuse replacement When replacing the fuse, be sure to use one matching the amperage rating stated on the original fuse. If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. In such a case,

Removing the unit

1Remove the protection collar.

1Detach the front panel (page 4).

2Engage the release keys together with the protection collar.

Orient the release keys as shown.

3Pull out the release keys to remove the protection collar.

consult your nearest Sony dealer.

Fuse (10A)

Cleaning the connectors

The unit may not function properly if the connectors between the unit and the front panel are not clean. In order to prevent this, detach the front panel (page 4) and clean the connectors with a cotton swab dipped in alcohol. Do not apply too much force. Otherwise, the connectors may be damaged.

Main unit	Back of the front
	panel

Notes

•For safety, turn off the ignition before cleaning the connectors, and remove the key from the ignition switch.

•Never touch the connectors directly with your fingers or with any metal device.

2Remove the unit.

1Insert both release keys simultaneously until they click.

Hook facing inwards.

2Pull the release keys to unseat the unit.

3Slide the unit out of the mounting.

11