Setting the clock

The clock uses a 24-hour digital indication.

1Press and hold the select button.

The setup display appears.

2Press the select button repeatedly until “CLOCK-ADJ” appears.

3Press (SEEK) +.

The hour indication flashes.

4Rotate the volume control dial to set the hour and minute.

To move the digital indication, press (SEEK) –/+.

5Press the select button.

The setup is complete and the clock starts.

To display the clock, press (DSPL). Press (DSPL) again to return to the previous display.

With the card remote commander

In step 4, to set the hour and minute, press M or m.

Tip

You can set the clock automatically with the RDS feature (page 10).

Detaching the front panel

You can detach the front panel of this unit to prevent theft.

Caution alarm

If you turn the ignition switch to the OFF position without detaching the front panel, the caution alarm will sound for a few seconds. The alarm will only sound if the built-in amplifier is used.

1Press (OFF).

The unit is turned off.

2Press , then pull it off towards you.

Notes

•Do not drop or put excessive pressure on the front panel and display window.

•Do not subject the front panel to heat/high temperature or moisture. Avoid leaving it in a parked car or on a dashboard/rear tray.

Attaching the front panel

Engage part A of the front panel with part B of the unit, as illustrated, and push the left side into position until it clicks.

A

B

Note

Do not put anything on the inner surface of the front panel.

5